Virtuoso IC6.16 - DC simulation - Annotate DC OP failed

[Chr's]

Hi everyone,

My issue is about a DC simulation.

When this one is finished, and I wanted annotate the DC operating points on the schematic, They are not displayed for all components.


For example, I've 2 dc sources, but the DC operating point is displayed only for one of them. I save all the points (Output -> Save all -> check boxes on "all").

If someone has the solution, thanks in advance.


Regards,

 

[chris.mourad]

Hi

Sometimes Cadence is a little bit tricky at some point when using save all .

Could you make sure that you save individually the nets you are interested in (outputs>to be saved>select on shcematic)?

 

[Chr's]

Hi

Sometimes Cadence is a little bit tricky at some point when using save all .

Could you make sure that you save individually the nets you are interested in (outputs>to be saved>select on shcematic)?

It's big schematic and I cannot select all the points, that's why select: save point "all"with a check box

 

[chris.mourad]

Hi

are you using spectre or eldo?

 

[Chr's]

It's with ADE_L and simulator spectre