Chr's
Junior Member level 1
Hi everyone,
My issue is about a DC simulation.
When this one is finished, and I wanted annotate the DC operating points on the schematic, They are not displayed for all components.
For example, I've 2 dc sources, but the DC operating point is displayed only for one of them. I save all the points (Output -> Save all -> check boxes on "all").
If someone has the solution, thanks in advance.
Regards,
My issue is about a DC simulation.
When this one is finished, and I wanted annotate the DC operating points on the schematic, They are not displayed for all components.
For example, I've 2 dc sources, but the DC operating point is displayed only for one of them. I save all the points (Output -> Save all -> check boxes on "all").
If someone has the solution, thanks in advance.
Regards,