mhughes
Newbie level 4
RF calibration kit
Hi all,
I am designing an RF calibration kit with short, open and load standards for PNA frequency domain measurements. Usually, the file loaded with any cal kit is a *.cst (state and cal set link) file. I was wondering how will it be possible to create my own cal and state file that will be loaded to the analyzer during calibration.
Any advice would be much appreciated.
Thanks,
Mike
Hi all,
I am designing an RF calibration kit with short, open and load standards for PNA frequency domain measurements. Usually, the file loaded with any cal kit is a *.cst (state and cal set link) file. I was wondering how will it be possible to create my own cal and state file that will be loaded to the analyzer during calibration.
Any advice would be much appreciated.
Thanks,
Mike