RF calibration kit - creating a new cal and state file

[mhughes]

RF calibration kit

Hi all,

I am designing an RF calibration kit with short, open and load standards for PNA frequency domain measurements. Usually, the file loaded with any cal kit is a *.cst (state and cal set link) file. I was wondering how will it be possible to create my own cal and state file that will be loaded to the analyzer during calibration.

Any advice would be much appreciated.

Thanks,
Mike

 

[kspalla]

RF calibration kit

Read the manual for calibration procedure.
When you are about to finish this procedure, system will ask for the file name in new machines or it will ask to replace the existing states with this new state in case of older NWA