huji
Member level 4
how to use protel
hi,
I am quite confused.. in protel dxp 2004 schematic i placed several hex inverter SN74F04D or op- amp TL084.. but the pin is still indicating that I am placing the same component.. how can I changed the pin so that it would continue to the 2nd hex , 3rd and so on for the hex inverter or op amp. and the other thing when I autoroute my pcb it would not autoroute itself and will show an error.. why is this.. i've already check for any mistake but there is non.. thanx
hi,
I am quite confused.. in protel dxp 2004 schematic i placed several hex inverter SN74F04D or op- amp TL084.. but the pin is still indicating that I am placing the same component.. how can I changed the pin so that it would continue to the 2nd hex , 3rd and so on for the hex inverter or op amp. and the other thing when I autoroute my pcb it would not autoroute itself and will show an error.. why is this.. i've already check for any mistake but there is non.. thanx