Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
Hi, I am simulating impedance profile in Hyperlynx PI. I have attached a profile. The impedance requirement is 0.1 Ohm or below. Which decoupling capacitors I should add of which package in order to have the impedance profile blow 0.1 Ohm.
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.
