Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Register Log in

A question about Protel99se,need your help!

Status
Not open for further replies.
D

dudleyzty

Junior Member level 2
Joined
Apr 21, 2002
Messages
24
Helped
0
Reputation
0
Reaction score
0
Trophy points
1,281
Activity points
109
When I create netlist from schematic project,I find some nets are treated
as different part! eg. I have only one VCC net,but
there're two VCC group in the netlist! By the way,I'm designing a four
layer PCB, almost all power nets have this problem. Some pads or vias
cannot be connected to associate power layer because this problem.

Who can help me? Thanks a lot!!
 

There was a problem like this in Pr0tel99SE - it was fixed in SP6. Do you have SP6 installed?
 

Status
Not open for further replies.

Similar threads

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top