dudleyzty
Junior Member level 2
When I create netlist from schematic project,I find some nets are treated
as different part! eg. I have only one VCC net,but
there're two VCC group in the netlist! By the way,I'm designing a four
layer PCB, almost all power nets have this problem. Some pads or vias
cannot be connected to associate power layer because this problem.
Who can help me? Thanks a lot!!
as different part! eg. I have only one VCC net,but
there're two VCC group in the netlist! By the way,I'm designing a four
layer PCB, almost all power nets have this problem. Some pads or vias
cannot be connected to associate power layer because this problem.
Who can help me? Thanks a lot!!
