Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Differential pair design guide?

Status
Not open for further replies.

elektrom

Full Member level 2
Full Member level 2
Joined
Jul 2, 2001
Messages
127
Helped
3
Reputation
6
Reaction score
1
Trophy points
1,298
Activity points
965
Any PCB design rule or guieline for LVDS, Optical channel

- track width
- spacing between differential wire
- twist angle
- spacing between pair
- ???
 

I also need them mentioned above. THKS
 

The layout of each LVDS pair needs special consideration.

If the distance separating the positive and negative trace is d, then the distance from the differential pair to another differential pair should be greater than 2d.

The distance from the differential pair to a GND or VCC trace should also be greater than 2d and
the distance from the differential pair to TTL signals should be greater than 4d.
about width it depend upon the stack of pcb..
8 mil for 50 ohm
generally d=8 to 10
for extra reference see the attach file..
 

I just found the e-book : High-Speed Signal Propagation-Advanced Black Magic

It's on e-book download section. At the first glance, I think this book could answer all my question. For the person who interest in this area, just read it.
 

Hello elektrom

You can also read this document: **broken link removed**
Should be very interesting for you
 

    V

    Points: 2
    Helpful Answer Positive Rating
Status
Not open for further replies.

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top