Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
The board I worked on had press fit on upper and lower edge so the template was for the entire board. I think as long as the SMT components near the press fit is not too tall them the recommended clearance is probably fine, but it all depends on how the template is made too.
I am not an expert...
I did couple of them while back also. The fixture was provided by the customer so I'm not sure what the cost is, but it was fairly simple metal plate with holes for the connectors so you can use a press to just push the connector together.
I think only problem I ran into was not specifying the...
I believe Altium had issue with DXF import directly to where you would make the footprint. I believe I called it into the board data then copied it over to the footprint. I haven't used Altium for a while so if it doesn't make sense please ignore it.
Can you not just use a plated hole with pad and place the center on the board edge? I'm not sure, but I don't think you'll be able to make a half plated hole.
Then again Altium has suprised me before with some of their stuff.
I don't use Altium enough to know for sure, but I know in other...
So is it ok to route solder mask covered traces closer as long as the exposed pads meet the required distance?
For example, I am required to have 3mm of gap with exposed copper, but only 1mm if it's covered.
Would I be able to route the traces under solder mask at 1 mm spacing as long as...
Hello all,
My situation is that I have the board data (.pcb, .rul) and the netlist in .ccf format. We do not have the library that is used on the board and when I try to forward annotate I get the error saying "error 43052: Part is unregistered in library. [ Part name = 502426-4010 ] [ part...
I was wondering if anyone had problems back annotating after pin swap. When I
back annotate pin swap in the BGA with a NC pin then the back annotation
is not done correct. Have anyone encountered this problem?
For example, pin from block one is moved to block 4 or vice versa.
Also had...
I would think contacting Cadence support would be the fastest solution. If you were able to do it before, then maybe reinstall? I suggest the support they are pretty responsive.
Re: allegro tool help
Yes, sign on Sourcelink then email them. Long as you have valid copy and license they are more than willing to help you with any questions.
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.
