Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
I have the following Microphone and I want it connect with my PC so that the sound-quality stays at maximum and I dont want do any harm to the Mic or Soundcard(Voicechip)Sholud I make some kind of mixer or sth??**broken link removed**
I want to connect my microphone (Shure PG58) with my computer voice chip. Should I make an adapter between them or can I just connect them directly.
The Microphone and Voice Chip should stay unbroken.
magnum metal detector
h**p://www.thunting.com/cgi-bin/geotech/pages/common/index.pl?page=metdet&file=/projects/magnum/index.dat - Some time ago we discussed about the detector, but I havent foud anywhere more information about it. For example. Does anybody now how deep it recognizes...
Well, I bought a Silicon Power iDear 256 MB MP3 player. I tried to setup windows 98SE so that it would recognize it, and it did. But my PC didn`t find the driver in Microsoft. I hadn`t a driver cd either. So I tried to load the songs with Knoppix 3.9, at first I tried to load 1 song. It played...
Well the thing is, I have a cat and when I go with it to the country, she always gets lost. I am sick and tired of searching for her trough the nights. So I want to build a watching-system that helps me to find her in the evenings. All ideas are welcome!
I want to build wireless microphones. They should use the UHF or VHF frequencies for not to disturb the other channels (radio, ambulance, police etc.). there are some frequencies ( above 860 or sth.) that aren`t illegal, but how should i built that sort of microphone? Any schemes, circuits?
Wireless microphones
I`ve got a serious problem. I want to make wireless microphones on my own using radio-frequency FM 88-108 MHz. But there are so many channels that all are disturbing the signal that has to reach from the microphone to the radio-reciever.
Has somone a idea or a scheme how...
I have the following problem.
I have to make a coil from 22 gauge wire ( 22 gauge = 0.6438 mm), but I could get only some 0.6 mm wire.
I have to make 8 to 10 turns on a 1/4'' diameter form.
How should I do it, when I want to make it work instead of a 0.6438 mm wire with a 0.6 mm wire?
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.
