I also would like to know which way the FETs are connected (although not critical)?
Is the drain towards the ground and the source towards the negative, or the other way round?
Source is at the top in the schematics. Note the supply rail is negative with respect to ground.
The baluns will work but be careful to ensure they are not self resonant near the oscillator frequency or they may distort the signal or worse, become the tuning element themselves.
Source is at the top in the schematics. Note the supply rail is negative with respect to ground.
The baluns will work but be careful to ensure they are not self resonant near the oscillator frequency or they may distort the signal or worse, become the tuning element themselves.
Thanks brian.
It is an interesting vfo isn't it? I will test it in a few weeks to see how it works. The capacitors are of relatively low values, so NP0 ones could be used. This will allow me to judge the circuit frequency drift without it being affected by the components ppm much.
Do you believe that with a suitable LC, it will be stable enough for SSB operation?
Do you believe that this oscillator could also work using a ctystal in place of the LC?