hi
I'm designing a phase shifter on RO4003. its Thickness is 20mil=0.508mm and i must Place this phase shifter in metallic box.
What kind of Connector is better suited for this?
by the way frequency is about 8 GHZ and board size is 40mm*40mm
any comment is welcomed
Thanks
Thanks for your comments.
There are so many SMA connector. in fact i need sme kinfd of practical advise and specific kind of sma. like end launch or simple straight?
thanks
Thanks for your comments.
There are so many SMA connector. in fact i need sme kinfd of practical advise and specific kind of sma. like end launch or simple straight?
thanks
it really depends on your requirements. There's no way anybody here can tell YOU what YOU need. I don't understand your confusion. If you can use a vertical, through-hole part, then use it.
it really depends on your requirements. There's no way anybody here can tell YOU what YOU need. I don't understand your confusion. If you can use a vertical, through-hole part, then use it.
Your Right Barry. It returns to my limitations. I'm not familiar with specific functionality of every kind of SMA connector. for example whats the deference's between bulkhead and straight Types?
I should place my design in Metallic House so it seems i can't use R/A or End launch?. so I think my only choices are straight and bulkhead!
sorry if my questions are so cheap. by the way Thanks