It required 3 width each, W1, W2 and W3. For my case, it means the 3 width is 3 mm each, since my width is 3mm at 2.5Ghz ( 50ohms)
I just connect them ? how about the length? How do I include it with my hardware fabrication ?
I didn't use any layout at ADS. I am using the schematic drawing only.
So as for my transmission line and the stub matching , the width are same = 3 mm.
Should I use any MTEE to connect them ?
i know the length wont affect the 50 ohm impendence, but then how do I connect them ?
As you seen from the previous attachment, all the transmission line and stub matching stripline are same width, 3 mm.
So the MTEE will same width too, 3mm.
Another thing, since it is same width from the beginning, why I still need a MTEE to connect them ?
See the following picture. The 1.jpg is schematic, the other is layout. If you draw schematics in AWR, and you can get layout from AWR. Then you can export layout file in dxf format, and then import dxf file into Altium. That is very easy and very accuracy.
You can search in this forum, I have posted how to converter AWR design into Altium.
good luck.