tomato_sos
Junior Member level 3
I found this: MTEE inside ADS.
It required 3 width each, W1, W2 and W3. For my case, it means the 3 width is 3 mm each, since my width is 3mm at 2.5Ghz ( 50ohms)
I just connect them ? how about the length? How do I include it with my hardware fabrication ?
It required 3 width each, W1, W2 and W3. For my case, it means the 3 width is 3 mm each, since my width is 3mm at 2.5Ghz ( 50ohms)
I just connect them ? how about the length? How do I include it with my hardware fabrication ?