timer/counter 1 problem in ccs pic compiler

Status
Not open for further replies.
N

Noman Yousaf

Full Member level 4
Joined
Nov 19, 2003
Messages
208
Helped
3
Reputation
6
Reaction score
2
Trophy points
1,298
Location
Lahore Pakistan
Activity points
1,763
hi
i want to get 16 bit data from timer/counter1 (as event counter) to portb and c in CCS.
how can i do it?

i did it by timer 0 as counter.

by following

SETUP_TIMER_0(RTCC_EXT_H_TO_L|RTCC_8_BIT|RTCC_DIV_2);
SET_TIMER0(0);

WHILE(1)
{

OUTPUT_B(GET_TIMER0());
}


one more problem i faced, in protuse, it increases after every 2 pulses to T0CLK pin.
 

18f252 t0 8 or 16bits
 

how to check either prescaler is used or not?

- - - Updated - - -

Noman Yousaf said:
how to check either prescaler is used or not?
Click to expand...

i actually want to use timer 1 as 16 bits. how to split the 16 bits into 8 bits to make it out to 2 ports (may b portb and c)
 

Noman Yousaf said:
i actually want to use timer 1 as 16 bits. how to split the 16 bits into 8 bits to make it out to 2 ports (may b portb and c)
Click to expand...

The TMR1 register in the PIC consists of two individual 8-bit registers to store the lower and upper nibbles.

Code: 
[syntax=c]

int main(){
TRISB = 0x00;      // PORTB as output
TRISC = 0x00;      // PORTC as output
// Configure timer 1 here

while(1)
{
  PORTB = TMR1L;
  PORTC = TMR1H;
}
}
[/syntax]
 
Last edited:

Try this.

Code C - [expand]
1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
16
17
18
19
20
21

#include <16F877.h>
#use delay(clock = 20000000)
#fuses HS,NOWDT<NOLVP
 
unsigned int overflow = 0;
 
#int_TIMER1
TIMER1_isr() {
    ++overflow;
}
 
void main() {
 
    setup_timer_1(T1_EXTERNAL | T1_DIV_BY_1 | 0x08);
    enable_interrups(INT_TIMER1);
    enable_interrupts(global);
 
    while(1) {
 
    }
}
 

Status
Not open for further replies.

Similar threads

Menu
Log in
Register
Cookies are required to use this site. You must accept them to continue using the site. Learn more…