Pyroflea
Newbie level 4
Hey, new here
I'm in search of a 3-axis stepper motor controller for as little money as possible. Be it prefab'd, or DIY, I'm open to both options. Microstepping would be nice as well, but is not necessary is the price is right.
As of now, I was looking at HobbyCNC PRO Chopper Driver Board Kit (located HERE).
I would preferably like to make something, just for the learning experience, but would go for a prefab'd unit, as mentioned above. I'm looking for the cheapest, yet still reliable, controller that I can find.
Thanks in advance for the help, lemme know if I missed any information
- Pyro
I'm in search of a 3-axis stepper motor controller for as little money as possible. Be it prefab'd, or DIY, I'm open to both options. Microstepping would be nice as well, but is not necessary is the price is right.
As of now, I was looking at HobbyCNC PRO Chopper Driver Board Kit (located HERE).
I would preferably like to make something, just for the learning experience, but would go for a prefab'd unit, as mentioned above. I'm looking for the cheapest, yet still reliable, controller that I can find.
Thanks in advance for the help, lemme know if I missed any information
- Pyro