splitting DC bias logic question

Y

yefj

Advanced Member level 4
Joined
Sep 12, 2019
Messages
1,233
Helped
1
Reputation
2
Reaction score
3
Trophy points
38
Activity points
7,404
Hello , I have an amplfier board of QPA2575 the DC feeding GND Is at metal_3_bot while the RF signal has ground at metal_2_mid.
The DC connector is HUGE as shown below,basicly i need to simultaniosly feed all 4 amplifiers.
From looking at the data sheet i have this schemtics shown in the last photo.
How do i build a feeding network for such a complex connector so if will feed all 4 amplifiers shown in the schematics below.
Thanks.

QPA2575 - Qorvo

www.qorvo.com










 

Attachments

  • 1690701118261.png
    8 KB · Views: 64

Sort by date Sort by votes
Hello, i have an amplifier QPA2575 which data sheet is attached.
As you can see below, i put the layout as i imagine it in the schematics.
for example if i what to simultaniosly power the drain_top(red arrow) DC input i dont know do to properly draw the trace from the main drain_top connector, to the sub (drain_top) at each amplifier.
Is there any intuition regarding how to simultaniosly power all four amplifiers?
Thanks.



 

Attachments

  • QPA2575 Data Sheet.pdf
    1.2 MB · Views: 68

Upvote 0 Downvote
You must log in or register to reply here.

Similar threads

Menu
Log in
Register
Cookies are required to use this site. You must accept them to continue using the site. Learn more…