SMA connector footprint

Status
Not open for further replies.

the_owl

Junior Member level 1
Joined
Sep 29, 2010
Messages
15
Helped
2
Reputation
4
Reaction score
2
Trophy points
1,283
Activity points
1,376
hello everyone,

anyone know the footprint for this SMA connector? I was looking for the footprint for few days but could't found. I would appreciate if u can provide me the footprint for this. Thanks!


**broken link removed**
 

can it be a through hole??
 

no this is Edge Mount Connector... You can use attached SMA Connector for Through hole....
Plz click this link
**broken link removed**[2005.06.30%2009.58.29].pdf
 

No this will be a Surface mount part. You have to be very careful with this because i think you cannot exceed the board thickness by 1.6 mm (63 mils).
 


ohh..so the footprint should be on both top and bottom surface as it is edge mounted??
 

Yes.. if the SMA Is Edge mounted then it should soldered on both top and Bottom side...
 

Status
Not open for further replies.
Cookies are required to use this site. You must accept them to continue using the site. Learn more…