CrabMan
Member level 1
Hi,
Is it possible to mix a different brands of ac servo motor and servo drive. I have a pretty obsolete servo motor from Nikki Denso Actus power 7.5KW rated at 120VAC.
The drive installed malfunctioned and now we have to replace the drive. The motor is running in position control mode in sync with another same motor. Both motors are installed on a flat-bed conveyor's two different ends, one is pushing and other is pulling. So my question is that can I configure a Mecapion or OMRON's AC servo drive on this motor? I dont want to change the motor because then "maybe" i will also have to change the other motor and drive too because of load sharing issues.
Any input will be helpful
Cheers
CrabMan
Is it possible to mix a different brands of ac servo motor and servo drive. I have a pretty obsolete servo motor from Nikki Denso Actus power 7.5KW rated at 120VAC.
The drive installed malfunctioned and now we have to replace the drive. The motor is running in position control mode in sync with another same motor. Both motors are installed on a flat-bed conveyor's two different ends, one is pushing and other is pulling. So my question is that can I configure a Mecapion or OMRON's AC servo drive on this motor? I dont want to change the motor because then "maybe" i will also have to change the other motor and drive too because of load sharing issues.
Any input will be helpful
Cheers
CrabMan