Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
this is my circuit how do i connect ir2110 gate driver to the mosfets, the sources of both the mosfets are shorted , isnt der any standard circuit , the supply to the circuit in the figure is 120vrms and expected output is 400vdc
plz do help
In the datashhet you find standard circuits.
For further information look at IRF.com for application notes on "FET driver", "MOSFETs" "driving MOSFETs" or "IR2110 application note" or similar to find related information.
klaus
- - - Updated - - -
Hi,
sorry, i just realized that the schematic is for AC switching (always both FETs on or both FETs off).
You cannot use IR2110 to drive these mosfets. Because the source voltage can be either negative or positive you will have to drive them with transformers.
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.