cristhemuso
Newbie level 4
Hi all. I am new to this forum so please be gentle.
I am planning to add an external aerial to improve reception of my camera wireless mic. I believe I can add an sma connector by removing the load resistor thus disconnecting the pcb aerial and attach a fine coax to sma connector.
I am not certain exactly where to make the connections for the attached picture. Any advice very welcome.
I think I attach the shield to the ground plane and the core to where the resistor is removed.
I cant fathom out exactly what the connections are in the picture....
Cris
I am planning to add an external aerial to improve reception of my camera wireless mic. I believe I can add an sma connector by removing the load resistor thus disconnecting the pcb aerial and attach a fine coax to sma connector.
I am not certain exactly where to make the connections for the attached picture. Any advice very welcome.
I think I attach the shield to the ground plane and the core to where the resistor is removed.
I cant fathom out exactly what the connections are in the picture....
Cris