goatmxj666
Member level 2
Hello,
I made RF power amplifier as IC including matching networks (input, output).
Now, I have to make PCB board for testing.
I wondering how do I design microstip line for my chip.
Should the microstrip line match between source 50 ohm and chip's input impedance?
The output matching network is already matched with 50 ohm.
If so, could I just design the microstrip line to be short and thick without matching the output impedance of the chip to 50 ohm?
I made RF power amplifier as IC including matching networks (input, output).
Now, I have to make PCB board for testing.
I wondering how do I design microstip line for my chip.
Should the microstrip line match between source 50 ohm and chip's input impedance?
The output matching network is already matched with 50 ohm.
If so, could I just design the microstrip line to be short and thick without matching the output impedance of the chip to 50 ohm?