DespoinaSavatage
Newbie
Hi all,
I am new to Ansys Electronics. I want to create a dynamic link between HFSS and Circuit, so I assign lumped ports at the points where I want to connect an active device in Circuit.
I do my analysis without the ports, however their addiction affects the results, since they come with a 50 Ohm impedance.
I am not sure what to do next. If I redesign the whole structure with these lumped ports, which only serve as pins/terminals for Circuit, I get a totally different result from what I want. Any ideas?
I am new to Ansys Electronics. I want to create a dynamic link between HFSS and Circuit, so I assign lumped ports at the points where I want to connect an active device in Circuit.
I do my analysis without the ports, however their addiction affects the results, since they come with a 50 Ohm impedance.
I am not sure what to do next. If I redesign the whole structure with these lumped ports, which only serve as pins/terminals for Circuit, I get a totally different result from what I want. Any ideas?