Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Matching of lumped port in HFSS

Status
Not open for further replies.
Joined
Feb 16, 2017
Messages
3
Helped
0
Reputation
0
Reaction score
0
Trophy points
1
Activity points
53
Hi all,
I am new to Ansys Electronics. I want to create a dynamic link between HFSS and Circuit, so I assign lumped ports at the points where I want to connect an active device in Circuit.
I do my analysis without the ports, however their addiction affects the results, since they come with a 50 Ohm impedance.

I am not sure what to do next. If I redesign the whole structure with these lumped ports, which only serve as pins/terminals for Circuit, I get a totally different result from what I want. Any ideas?
 

PlanarMetamaterials

Advanced Member level 4
Joined
Jun 13, 2012
Messages
1,331
Helped
390
Reputation
782
Reaction score
347
Trophy points
1,363
Location
Edmonton, Canada
Activity points
8,959
Welcome DespoinaSavatage,

The ports represent your active circuit, so yes, you want them in there. The HFSS simulation in this context doesn't mean much, the useful results will be the cosimulation results.
 

Status
Not open for further replies.

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Top