Hello everyboby?
When I create component in Part Developer, I assert type for pin. Load column has two fields, Low and High. The values of output Low and
High fields determine the low and high output load values for the pin in mA. Why high output load values for the pin has negative value?
I think it's dont correct. Analogue situation with type BIDIR.
Thank you.
Regards Serg.
:?:
Negative value for the current of the output pin at high logic level indicates that the pin is sourcing current, not sinking. This is so because the positive direction for the current is "into the pin" (from outside).
Maranaza, Thank you for you answer, but if negative value high logic level indicates that the pin is sourcing current, then Why low output load values for the pin has positive value?