Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Instantaneous capacitor current.....

Status
Not open for further replies.

archie18

Newbie level 3
Newbie level 3
Joined
May 28, 2009
Messages
4
Helped
0
Reputation
0
Reaction score
0
Trophy points
1,281
Activity points
1,309
Hello Everbody,
I have one doubt about capacitor discharge current.
I am charge a 0.47uF capacitor through 5.6K resistor. Vcc is 5Vdc
After some time say 1 min I directly short the capacitor without any resistor ...what would be the instantaneous discharge current ?
Thx,
 

It deppends of the Equivalent series Resistor (ESR) of the capacitor that usually is small. SO the current is V/ESR = I
It is a very bad practice to do that because the life of the capacitor decreases, thr robability of failure increases. If it is an electrolitic capacitor it could be damage in only one try.A good practice is using a resistor that takes several seconds to discharge.
 
Status
Not open for further replies.

Similar threads

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top