Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

IBIS: Pulldown curve and Gnd Clamp Waveform

Status
Not open for further replies.

skynet

Member level 5
Joined
Apr 18, 2002
Messages
80
Helped
2
Reputation
4
Reaction score
1
Trophy points
1,288
Activity points
638
Hi,

I try to simulate Pulldown simulation and Ground clamp simulation, it seem that both of the waveform are look alike, I believe that my testbench to test the buffer is correct, where Ground Clamp simulation, EN=1.8, VIn=0, while for Pulldown, EN=0, VIn=0. I can't get the waveform which is similiar to the Cook book.

best regards
SkyNet
 

Status
Not open for further replies.

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top