Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronic Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Register Log in

I need a DC Motor for my Eagle project

Status
Not open for further replies.

essedra

Newbie level 5
Joined
Nov 19, 2009
Messages
8
Helped
0
Reputation
0
Reaction score
0
Trophy points
1,281
Activity points
1,342
I need a DC Motor for my Eagle schematic, a DC Motor like this one:



but I couldn't find such a DC Motor when I checked out my Eagle library. Where can I find a ready-to-use component that is created by someone else?

Many thanks in advance.
 

jpanhalt

Advanced Member level 3
Joined
Jun 28, 2010
Messages
724
Helped
216
Reputation
442
Reaction score
219
Trophy points
1,323
Activity points
6,964
Do you plan to put the motor on the PCB? If not, as I suspect, just use whatever connector you will be using. That will take care of the electrical connections. Then you can just label or draw whatever you need to make it look the way you want it.

John
 

essedra

Newbie level 5
Joined
Nov 19, 2009
Messages
8
Helped
0
Reputation
0
Reaction score
0
Trophy points
1,281
Activity points
1,342
What I'm trying to built is a circuit diagram like this:



and I also need to draw an Eagle schematic, layout and to print a PCB file.
 

jpanhalt

Advanced Member level 3
Joined
Jun 28, 2010
Messages
724
Helped
216
Reputation
442
Reaction score
219
Trophy points
1,323
Activity points
6,964
You already have the schematic, minus a few parts. You need to decide what type of connectors you will be using for the two voltages and whether the switch and motor will be on the PCB or not. If not, then they both will need connectors too.

If the motor will be on the board, drawing a device for it will not be difficult and I would be happy to do that for you. You would need to provide the exact dimensions for the motor mounting and supply connections as well as its outline.

John
 

Status
Not open for further replies.
Toggle Sidebar

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Top