cdz
Junior Member level 2
Hi all,
I am using 90nm technology. After I use PLS and create the config view to do the simulation. In the AE, it is no problem that the ti run fast enough for just a few cells. After I want simulate the whole circuit, it because very small. In my circuit, there are 8 DFFs, 8 XOR and 16 Buffer and another huge output stage. in the output log, it display:
capacitor 63011
resistor 29217.
so the netlist is very big and it is very slow. it may take more than a week to finish the simulation. Does anyone have idea how to increase the simulation speed?
Thanks in advance.
I am using 90nm technology. After I use PLS and create the config view to do the simulation. In the AE, it is no problem that the ti run fast enough for just a few cells. After I want simulate the whole circuit, it because very small. In my circuit, there are 8 DFFs, 8 XOR and 16 Buffer and another huge output stage. in the output log, it display:
capacitor 63011
resistor 29217.
so the netlist is very big and it is very slow. it may take more than a week to finish the simulation. Does anyone have idea how to increase the simulation speed?
Thanks in advance.