Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

How to relate the device of CDL and layout in LVS?

Status
Not open for further replies.

jaylin

Junior Member level 1
Joined
Dec 24, 2005
Messages
17
Helped
0
Reputation
0
Reaction score
0
Trophy points
1,281
Activity points
1,581
.cdl file lvs

Hi Guys,

Can anybody tell me that how to write the command in LVS rule file for relating the devices of CDL and Layout, for example, if I define an element BJT[VN] in the rule, and I want to relate it with the a vertical NPN in CDL which model name is VNPN1, then how to write for these.


Thanks a lot

Regards
Jay
 

Robert Qi

Member level 2
Joined
Sep 24, 2005
Messages
49
Helped
3
Reputation
6
Reaction score
1
Trophy points
1,288
Location
Shenzhen, P.R China
Activity points
1,689
calibre lvs n3

I am not know clearly what you mean.
But if you use calibre, just modifing the "Form Device" section of the command file can do.
Or your modifing the model name VNPN1 of the CDL to VN also can do.
 

jaylin

Junior Member level 1
Joined
Dec 24, 2005
Messages
17
Helped
0
Reputation
0
Reaction score
0
Trophy points
1,281
Activity points
1,581
I use dracula in Candence, then how do to it.


Thanks a lot
 

vbhupendra

Full Member level 4
Joined
May 11, 2005
Messages
235
Helped
15
Reputation
30
Reaction score
8
Trophy points
1,298
Location
GOA, INDIA
Activity points
3,219
here is an example
if you have PM NM as PMOS or NMOS in CDL output file
and P3, N3 in LVS rule file
then just include following line on top of CDL file

*.EQUIV PM=P3 NM=N3

so in your case

*.EQUIV VN=VNPN1
 

Status
Not open for further replies.

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Top