how to eleminate connection interchange?

[janasuvvala]

Hello All,
i am using cadence 16.0 tool for PCB Designing.when i tried to route the components which are connected in parallel the nets are taking the shortest path instead of what the sequence followed in capture.i mean if we r connected fr0m R1-R2-R3.if we drag R3 close to R1 it will take direct path instead of going to R1.plese let me know the solution to avoid such problem.

 

[captainshahid]

leave more space between two components.

 

[janasuvvala]

leave more space between two components.

Thank u................

Due to space constraint we cannot do that all the time.Please let me know if there is any setting for that?

 

[power_yang]

You should place these components in sequence.
And you can connect these resistors one by one first of all.
And the last thing is to connect this copper with the other components.
By the way, follow the capture schematic is a good way to control current flow.

---------- Post added at 12:38 ---------- Previous post was at 12:36 ----------

You should place these components in sequence.
And you can connect these resistors one by one first of all.
And the last thing is to connect this copper with the other components.
By the way, follow the capture schematic is a good way to control current flow.