Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

How to convert layout from PROTEL file to CADENCE

Status
Not open for further replies.

amjad

Full Member level 5
Joined
Dec 29, 2002
Messages
274
Helped
9
Reputation
18
Reaction score
5
Trophy points
1,298
Activity points
2,291
How to convert layout from PROTEL file to CADENCE?

Regards,
Amjad
 

House_Cat

Advanced Member level 4
Joined
Feb 21, 2002
Messages
1,371
Helped
406
Reputation
812
Reaction score
98
Trophy points
1,328
Location
USA
Activity points
16,416
You cannot do a direct conversion of a layout from Pr0tel to C@dence.

The best you could do would be to export the netlist from Pr0tel, then use that netlist in Allegr0 or 0rcad. There are several different netlisters available on the @ltium website. See: https://www.altium.com/Community/Support/Downloads/ and look under "Additional Output Generators".

You could also output a .DSN file that can be used by C@dence layout software.
 

Status
Not open for further replies.

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Top