Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
Re: How to convert boardmaker2 files into PADS, Eagle or Are
I have old schematics and pcbs and i'm recreating them as needed. The oldest one's are in bm2 format. I can open it but it's a bit difficult to work on bm2. If it could be tanslated into one of the above programs that i have mentioned, the would be more easier
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.