Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Register Log in

how to configure Calibre to ignore small resistance when doing PEX?

Status
Not open for further replies.
X

xuyue1983

Newbie
Newbie level 3
Joined
Feb 7, 2012
Messages
3
Helped
0
Reputation
0
Reaction score
0
Trophy points
1,281
Visit site
Activity points
1,328
Hi folks,

I have a very large netlist, so the simulation is very slow. Now I want to configure Calibre PEX such that it ignores some resistance below a given value to reduce size of the netlist.
Is there any way of doing that? Any switch I can turn on or any threshold value I can set in Calibre PEX?
Thanks.
 

Status
Not open for further replies.

Similar threads

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top