Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
i know how to choose C58 by this
C*RL(Generally50Ω)≧(3~5)T/2
i use software to Simulation,find when r43 is changed,amplitude of V is changed ,but how to decide r43 and c59
They depend on the desired demodulation bandwidth and output loading impedance. The 0.01 uF cap after the diode will also impact bandwidth of demodulated signal based on driving impedance and diode resistance.
actually i did it ,when rf amplitude is constant,R value influence output value(voltage),but i dont know if it is the reason that R is here,and how to chose R 's value
After the power detector, if you connect to a OpAmp, the series resistor is always 1K~10K.
And, normaly, there should be a big resistor, say 100K, from the detector output to GND.
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.