Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Register Log in

how to align wire with pads

Status
Not open for further replies.
bilgekaan

bilgekaan

Full Member level 2
Full Member level 2
Joined
Nov 18, 2004
Messages
125
Helped
15
Reputation
30
Reaction score
1
Trophy points
1,298
Location
Turkiye
Activity points
1,300
Hi,

When I tried to route pcb manually , I could not align wire with pads. Wire always start out of pad bounds.(look at the pictures) How can align them ? Which settings is used for this?
 

LET ME KNOW WHICH TOOL U R USING

NORMALLY..
THIS MAY BE DUE TO U R GRID SETTINGS
SET THE GRID FOR ITS MINIMUM VALUE
OR TURN OFF THE SWAP TO GRID OPTION
 

Status
Not open for further replies.

Similar threads

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top