Help Connecting Device with Proteus

[brian25]

how's the connection between this device? and i want to use Proteus to simulate my program..

i do this connection and i try swapping rx and tx but still cannot communicate with each devices

usb-uart -------- GSM Shield
RX -------------- RX(Pin 3)
TX -------------- TX(Pin2)
Gnd -------------- Gnd

Proteus
Compim ---------- MCU
RX -------------- RX
TX -------------- TX


http://www.e-gizmo.com/KIT/USB.htm

http://www.e-gizmo.com/KIT/gsm%20shield.html

 

[brian25]

up.............................

- - - Updated - - -

up.............................

i used the softwareserial tx(2)-rx(3) in GSMLib of arduino and still don't work i cannot get any message in virtual terminal of Proteus. then i try to change the Softwareserial tx(1) - rx(0) the default state but still have no characters in message in virtual terminal..

#include <SoftwareSerial.h>
 
SoftwareSerial mySerial(0, 1); // RX, TX pins
 
void setup() {
 
pinMode(13, OUTPUT); // Initialize pin 13 as digital out (LED)
pinMode(8, INPUT); // Our button pin
mySerial.begin(4800); // Open serial connection at baud rate of 4800
 
}
 
void loop(){
 
if (digitalRead(8) == HIGH){ // On button press
digitalWrite(13, HIGH); // Turn LED on.
mySerial.println("AT"); // Sends AT command to wake up cell phone
delay(500);
mySerial.println("AT+CMGF=1"); // Puts phone into SMS mode
delay(1000); // Wait a second
mySerial.println("AT+CMGW=\"+09983944911\""); // YOUR NUMBER HERE; Creates new message to number
delay(1000);
mySerial.print("Sent from my Arduino."); // Message contents
delay(1000);
mySerial.write(byte(26)); // (signals end of message)
delay(1000);
mySerial.println("AT+CMSS=1"); // Sends message at index of 1
digitalWrite(13, LOW); // Turn LED off
delay(250);
digitalWrite(13, HIGH); // Turn LED on.
delay(10000); // Give the phone time to send the SMS
mySerial.println("AT+CMGD=1"); // Deletes message at index of 1
digitalWrite(13, LOW); // Turn LED off.
delay(250);
}
 
}