Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

[SOLVED] epm 7128s pin configuration

Status
Not open for further replies.

anilkumaradapa

Newbie level 2
Joined
May 23, 2011
Messages
2
Helped
0
Reputation
0
Reaction score
0
Trophy points
1,281
Activity points
1,291
I am using epm7128s in one board, I tried to output just a word 1010 through four o/p pins.
I am not getting any output, I feel that there may be some problem with using OE1 and OE2. I tied OE1 to ground, is it necessary to declare it as input in pin assignment.
 

FvM

Super Moderator
Staff member
Joined
Jan 22, 2008
Messages
50,238
Helped
14,526
Reputation
29,324
Reaction score
13,510
Trophy points
1,393
Location
Bochum, Germany
Activity points
288,445
I feel that there may be some problem with using OE1 and OE2.
These pins don't have a function in your design unless you assigned them explicitely.
 

Status
Not open for further replies.

Similar threads

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Top