eem2am
Banned
Design rules check
hello,
i am laying a pcb out with Pulsonix.
it is battery powered 10W boost converter.
Any good primers available or tips for Pulsonix?.
Especially, i know how to sync the .sch and .pcb files, but when you have layed it all out...how do you know its the same as the .sch ?
the Dsign rules checker always gives errors , so how do you know if you have an equivalent connection or not?
hello,
i am laying a pcb out with Pulsonix.
it is battery powered 10W boost converter.
Any good primers available or tips for Pulsonix?.
Especially, i know how to sync the .sch and .pcb files, but when you have layed it all out...how do you know its the same as the .sch ?
the Dsign rules checker always gives errors , so how do you know if you have an equivalent connection or not?