hi guys i was hoping you might be able to help me i want to achieve from 12vdc in 180vdc out but i need it so that the voltage level a micro controller can alter the voltage level if you could help i would be greatful
* You'll need to make it impossible for the microcontroller to be exposed to 180V.
* You'll need to start out with a gating waveform at a high duty cycle (managed by the microcontroller). Eventually the output voltage will rise to 180V. Then you will reduce the duty cycle.
* You'll need to divide down the output voltage, to a range of 0 to 5V, so it can be measured by the microcontroller.
* Since a 180V reference voltage is not available to compare your output to, you will need to create a scaled down unchanging reference voltage.
so i am bit unsure on dc to dc converters especially setup boost converters and there power and voltage transformation ratio are like especially something that would deliver 12vdc in and 180vdc out
What about just paralleling full bridge converters till each has a manageable current.
Then adjust your vout by having an external error amplifier(s) driving the pwm chip.....make the reference voltage into the external error amplifier variable , commanded by the micro, that will give you vout variation.
What about just paralleling full bridge converters till each has a manageable current.
Then adjust your vout by having an external error amplifier(s) driving the pwm chip.....make the reference voltage into the external error amplifier variable , commanded by the micro, that will give you vout variation.