Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

crystal PAD connection

Status
Not open for further replies.

toonboom1

Newbie level 4
Joined
Aug 30, 2009
Messages
6
Helped
0
Reputation
0
Reaction score
0
Trophy points
1,281
Location
Egypt
Activity points
1,313
hi all,

i'm trying to do a layout with i/o pad
this is what i think
the chip has a clock and the clock is generated using crystal oscillator
i had found in the technology files which i had that there is crystal pads but it contain too low info about it so i don't know how to connect them
there are 2 crystal pads with the same circuit
its truth table and verilog is attached
my problem is how to get one output ( clock) from two PADS of the oscillator
any suggestions?

thx in advance
 

Status
Not open for further replies.

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Top