eng.msmahmoud
Newbie level 5
Dear all
am using the following module as TX-RX remote control, i need your help in connecting the output of the relays to the microcontrolling to implmnet my algorithm
after some searching i got that i may connect this output directly to the micro-controller, but i cannot understand what is meant by rely stat :
A pin is close
B pin is opne and close
C pin is open
**broken link removed**
am using the following module as TX-RX remote control, i need your help in connecting the output of the relays to the microcontrolling to implmnet my algorithm
after some searching i got that i may connect this output directly to the micro-controller, but i cannot understand what is meant by rely stat :
A pin is close
B pin is opne and close
C pin is open
**broken link removed**