jelydonut
Full Member level 4
I have reciently recieved finished silicon and am currently trying to get timing for the datasheet. Currently how I am doing it is to capture waveforms on a logic analyser and compare them to the SDF timing in simulation. If the same, then I will use the simulation for generating the timing values.
Is this a proper way of doing this, or is there a better/easier way?
I've never seen any docs or anything on this step and am unsure if this is the proper way.
Any suggestions are appriciated.
Thanks!
jelydonut
Is this a proper way of doing this, or is there a better/easier way?
I've never seen any docs or anything on this step and am unsure if this is the proper way.
Any suggestions are appriciated.
Thanks!
jelydonut