heynyo
Newbie level 1
I installed IC 5.1.4.1 and MG Calibre 2004 on Red hat
I can stream out the layout and run DRC from command line so I think it rules out license setup problem. I also read the previous threads about setting up the pull-down menu in virtuoso and follow the steps accordingly. Finally I get to see the Calibre menu on top-right of virtuoso's toolbar.
But here comes the problem. When I click on Run DRC, nothing happened. In CIW, the message shows that DRC is invoked but nothing pops up.
Can anyone help me out?
here's some detail:
my .cshrc file
#################################################
setenv LM_LICENSE_FILE /CADTOOL/mentor/ixl_cal_2005.1_10.20/lic_cal.lic
setenv MGC_HOME /CADTOOL/mentor/ixl_cal_2005.1_10.20
set path=($path $MGC_HOME/bin)
#################################################
my .cdsinit file
###################################
load(strcat(getShellEnvVar("MGC_HOME")
"/shared/pkgs/icv.ixl/tools/queryskl/calibre.skl"))
mgc_rve_init_socket(9189)
###################################
CIW starts up with a message:
// Calibre layout-server initialized successfully at socket 9189
In the Calibre pull-down menu, everything works fine except for Run DRC and LVC and PEX buttons. After clicking them, CIW shows:
Running on Linux MOEMS 2.4.21-20.EL #1 wed Aug 18
20:58:25 EDT 2004 i686
Starting time : Wed Aug 27 13:56:41 2008
Nothing comes out. I don't know what I am missing.
Thanks for the reply.
heynyo
I can stream out the layout and run DRC from command line so I think it rules out license setup problem. I also read the previous threads about setting up the pull-down menu in virtuoso and follow the steps accordingly. Finally I get to see the Calibre menu on top-right of virtuoso's toolbar.
But here comes the problem. When I click on Run DRC, nothing happened. In CIW, the message shows that DRC is invoked but nothing pops up.
Can anyone help me out?
here's some detail:
my .cshrc file
#################################################
setenv LM_LICENSE_FILE /CADTOOL/mentor/ixl_cal_2005.1_10.20/lic_cal.lic
setenv MGC_HOME /CADTOOL/mentor/ixl_cal_2005.1_10.20
set path=($path $MGC_HOME/bin)
#################################################
my .cdsinit file
###################################
load(strcat(getShellEnvVar("MGC_HOME")
"/shared/pkgs/icv.ixl/tools/queryskl/calibre.skl"))
mgc_rve_init_socket(9189)
###################################
CIW starts up with a message:
// Calibre layout-server initialized successfully at socket 9189
In the Calibre pull-down menu, everything works fine except for Run DRC and LVC and PEX buttons. After clicking them, CIW shows:
Running on Linux MOEMS 2.4.21-20.EL #1 wed Aug 18
20:58:25 EDT 2004 i686
Starting time : Wed Aug 27 13:56:41 2008
Nothing comes out. I don't know what I am missing.
Thanks for the reply.
heynyo