Audio Jack 3.5mm: CONN JACK STEREO R/A 5PIN 3.5MM

Status
Not open for further replies.
L

lulach

Newbie level 3
Joined
Jun 3, 2011
Messages
4
Helped
0
Reputation
0
Reaction score
0
Trophy points
1,281
Activity points
1,308
Hi, I'm trying to make a PCB design but I can't find the footprint for the audio Jack.
Here is the link to the datasheet:
**broken link removed**
If someone can just tell me which group of footprints it is in and I can search through those. But I'm at witts' end, any help would be greatly appreciated.
Here is a picture and more details if it will help:
Digi-Key - CP1-3525N-ND (Manufacturer - SJ1-3525N)
Thanks in advance.
 

It will be in the group of footprints that "you make"

P.S. I do not think you mentioned which software you are using.
 

This is the data sheet with all the relevent information to create the footprint. Welcome to PCB design.
**broken link removed**
 

Ok, cyberrat I'm not against making the footprint... But again I'm completely lost.
I tried to make the footprint once, but I was confused about how to set pad spacing and how to set physical dimensions for the outside rectangle.
Can you help me with that?

---------- Post added at 14:03 ---------- Previous post was at 14:02 ----------

Also I am using cadence 16.2!
 

Status
Not open for further replies.

Similar threads

Menu
Log in
Register
Cookies are required to use this site. You must accept them to continue using the site. Learn more…