Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

[SOLVED] About DE0-Nano Board Configuration Device

Status
Not open for further replies.

hsnhsyn1

Junior Member level 1
Joined
Mar 19, 2013
Messages
16
Helped
0
Reputation
0
Reaction score
0
Trophy points
1,281
Activity points
1,400
Hi, I have a DE0-Nano Board and when i turned its power off after programming then turned on again, it always loaded its default program. The user manual says that even the power is turned off, the information is retained in the configuration device (Spansion EPCS64). So, everytime i turned its power on, i have to program the board again.
I don't have much knowledge about FPGA. I read the user manual but couldn't find anything about it. Is it something that i must do while programming the device with quartus II programmer? Any help would be appreciated.
 

FvM

Super Moderator
Staff member
Joined
Jan 22, 2008
Messages
49,119
Helped
14,379
Reputation
29,022
Reaction score
13,130
Trophy points
1,393
Location
Bochum, Germany
Activity points
283,155
I read the user manual but couldn't find anything about it.
Another word for sloppy reading?

Please read chapter 3.1, paragraph Configuring the EPCS16 device
and 9.1 Programming the serial configuration device
 
Status
Not open for further replies.

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Top