8 wired stepper motor,help!!!

[maxcmp]

Hi all,
I need sincere advice.

I have a project in which i have to control a 8 wire stepper motor.

Stepper motor will be controlled by GPIO for rotating an antenna. Can i using the IC ULN 2003 as a driver to control the stepper motor?
Can somebody suggest a 8 wire motor controller circuit by using a ULN 2003?

 

[FvM]

To answer the question, the motor specification (winding resistances, rated current must be known). Generally, ULN2803/2003
only allows unipolar operation of a stepper motor, the torque will be reduced compared to bipolar operation. You also have
to check, if ULN2803/2003 can drive the required motor current.