doopler
Newbie level 1
Hi,
I have two versions of dcshell. In the old one floated pins are constrained to the "0" value, but in the new one design is created with new, floated wire connected to this port instead of constraint. How to connect all of this kind of pins to constant value or to left them unconnected ?
I have two versions of dcshell. In the old one floated pins are constrained to the "0" value, but in the new one design is created with new, floated wire connected to this port instead of constraint. How to connect all of this kind of pins to constant value or to left them unconnected ?