Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Register Log in

ALTIUM CUSTOM FOOTPRINT FROM REGION , problem

Status
Not open for further replies.
K

keen

Full Member level 2
Joined
Jul 18, 2001
Messages
123
Helped
2
Reputation
4
Reaction score
2
Trophy points
1,298
Activity points
881
hi all, pls an advice, custom footrprint .

- footprint from region with pads was created .. its ok
- routing: than, when I manualy route PCB nets, track properly avod footprint region if it is not connected on this region .. its ok
when Situs rout nets, tracks go over the footprint region, WHY ???? something somewhere I did not set ?? WHO knows ?
BC I am a littlebit tired from Pdf's ..

regards .. me
 

Kapil,

what do you mean with 'datasheet' ? maybe you mean a picture ?

me .. alt01.JPG
 

Status
Not open for further replies.

Similar threads

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top